View Full Version : Manually opening slide out
markjamestx
06-27-2019, 05:52 PM
How do you manually open or close a slide out when you do not have a power source? Of course Keystone provides the wrench to do this that where does it tell you in the owner's manual how to use it?
chuckster57
06-27-2019, 05:57 PM
Can you post a picture of the “wrench”?
There are different types of slides and I don’t remember any needing a wrench to manually operate.
markjamestx
06-27-2019, 06:04 PM
Cannot do at this time but it is a flexible shaft that slips into a drill. It's about 12 inches long in the trailer came with two of them
sourdough
06-27-2019, 06:38 PM
Sounds like your talking about a cable slide with the motor on top.
chuckster57
06-27-2019, 06:50 PM
Sounds like your talking about a cable slide with the motor on top.
Yup!! The bit goes into a slot that will run the gearbox to move the slide in/out. You probably have 2 slides, but you only need 1 “wrench”.
Google “norco accuslide” and the directions to use it should be available.
notanlines
06-28-2019, 04:50 AM
Mark, how do you beat that; your answer in less than an hour! We've generally found the 'slot' inside the RV above the valance trim at the top of the slide.
vBulletin® v3.8.9, Copyright ©2000-2024, vBulletin Solutions, Inc.