Auto-Level BCM Troubleshooting?

[champyun]

My BCM (Body Command Module) comes on when I push the power button, but it does not go to any other screen when I push AUTO MODE, etc. Ideas anyone?

Notes:
I have a BAL 7.1 system on my 2017 Outback.

[ctbruce]

Dont have a clue but I'm positive someone on here will. Good luck.

[meaz93*]

I have the B.A.L. 7.3 on my 18` Outback.
By chance is your battery low?
Otherwise....possibly disconnect the battery for a while; check voltage, recharge than reconnect.
Try cycling through the buttons.
Hope you get it figured out.

[champyun]

I have the B.A.L. 7.3 on my 18` Outback.
By chance is your battery low?
Otherwise....possibly disconnect the battery for a while; check voltage, recharge than reconnect.
Try cycling through the buttons.
Hope you get it figured out.

Thanks for the info. I believe my batteries/voltage are/is fine, yet I will give that a try.

[ChuckS]

if you have no resolved the issue yet it sounds like your BCM needs a simple reset at the BCM

[champyun]

Where would this reset button be on the BCM?