Keystone Fuzion - Hawk Scare Light Lens

[SactoGuy]

Hello folks
Our 2008 Keystone Fuzion has four of these exterior lights, one on porch, two on ramp and one on left side. One of the lens is cracked and as my luck would have it, it is discontinued. Through my research, I have confirmed the light is a Hawk Scare, mfg by ITC RV. I found a similar one on eBay, Owl light? Wondering if any of you have dealt with this or found a replacement? I’d rather not change to a different style light and leave exposed holes on our trailer.
Any ideas?

[ctbruce]

Did you check with Trekwood?

[SactoGuy]

Did you check with Trekwood?



No, I have not checked with Trekwood. I’m also going to send an email to Keystone and see if they have any advice. The results have been disappointing most times that I have checked with Keystone on several things.

[JRTJH]

Here are three sources:

http://specialtymarinecenter.com/product/hawk-scare-light-manufacturers-select/
http://superdealsrvparts.com/scare-light%2C18-2323%2C%2C
http://www.2040-parts.com/hawk-scare-light-itc-incorp-81760-d-scare-light-lights-exterior-rv-i2166052/

While not cheap, the lens and light are still available, at least for now. The manufacturer has stopped production, so if the other three lights look like they may be aging, you might consider buying replacements while they are still available or look at alternatives that would cover the mounting sites with newer lights that are available.

Anyway, here's where you can find them, at least for now.

[SactoGuy]

Here are three sources:



http://specialtymarinecenter.com/product/hawk-scare-light-manufacturers-select/

http://superdealsrvparts.com/scare-light%2C18-2323%2C%2C

http://www.2040-parts.com/hawk-scare-light-itc-incorp-81760-d-scare-light-lights-exterior-rv-i2166052/



While not cheap, the lens and light are still available, at least for now. The manufacturer has stopped production, so if the other three lights look like they may be aging, you might consider buying replacements while they are still available or look at alternatives that would cover the mounting sites with newer lights that are available.



Anyway, here's where you can find them, at least for now.



Thanks for the info, I’ll look into this!
I don’t necessarily care the lights, however I’d rather go back with them to eliminate more screw holes. Also, many of the new style lights are much smaller, which would leave the old screw holes visible.