View Full Version : Winegard omni
BamaRam
09-22-2018, 01:31 PM
Is there any way to release the “frisbee” from the mounting tube?
The pigtail from the antenna is inside the tube and it has an intermittent connection.
I took this pic through the mounting hole for a cabin lamp that happens to be under the antenna.
chuckster57
09-22-2018, 01:35 PM
Most likely you’ll have to take the whole thing off. Peel the Dicor and then you’ll see the screws.
BamaRam
09-22-2018, 01:38 PM
I was afraid you’d say that. It’s under warranty so maybe I can live with it until I get home.
BamaRam
09-22-2018, 04:10 PM
Most likely you’ll have to take the whole thing off. Peel the Dicor and then you’ll see the screws.
Chuck, off topic but should that area be insulated?
chuckster57
09-22-2018, 04:25 PM
It most likely is, you just can’t see it from the interior.
BamaRam
09-22-2018, 05:35 PM
There is no insulation between the ceiling liner and the 3/8” OSB . I used a small mirror and light to look in the cavity and there’s a large open area. I am assuming the roof membrane lies directly on the OSB, so it appears that it’s not insulated.
Maybe I need to drop more ceiling fixtures and look around. ??
chuckster57
09-22-2018, 05:37 PM
You could, but then you might get more disappointment.
BamaRam
09-22-2018, 05:54 PM
You could, but then you might get more disappointment.
LOL. I found some along the side of the ceiling but the middle is bare. At least in that spot.
vBulletin® v3.8.9, Copyright ©2000-2024, vBulletin Solutions, Inc.