Ddubya
08-20-2018, 04:25 AM
Our In Command holding tank indicators just started to only indicate 1/3 full no mater how full the tanks are on all four tanks. I am familiar with the issues of fouled sensors but that would not cause this. I checked the voltage at the In Command terminals and all read about 2.4 volts which is correct for 1\3 full. The voltage never goes above that even with a full tank.
Just spoke to Jensen and they suggested calling Keystone. Called Keystone and they suggest installing In Command software update and recalibrate. Since it has worked for two years I have doubts that will solve the issue
Just spoke to Jensen and they suggested calling Keystone. Called Keystone and they suggest installing In Command software update and recalibrate. Since it has worked for two years I have doubts that will solve the issue