Easy Set Remote question

[Mcrafty1]

My new to me 2011 Montana has the Easy Set Remote Control system, I found my remote along with the rest of the camper info packet in the freezer.....after it had been on for a few days. The battery in the controller appears to be dead, my question is how do I get the controller apart to change it? The one screw at the bottom doesnt let the case be seperated.

[JimMach1]

Can you post a picture? Of remote

[Mcrafty1]

This is the front. The back has an overlay with directions for opetation glued on.

[Mcrafty1]

This is the back

[JimMach1]

Mine has a charging port like a phone has I’m unsure on yours?

[JimMach1]

My old one had a door on the bottom that slid out

[Mcrafty1]

My old one had a door on the bottom that slid out

No door and no charging port. When I remove the screw from the lanyard bracket on the bottom end I can pry the case open enough to se a AAA battery but not enough to change it. Something seems to be holding the case solidly together near the center of the case.

[JRTJH]

I wonder if there's a Phillips screw "dead center" under that instruction decal? Maybe an "inquiring fingernail" run across the back may locate the indentations of the screwhead ????

[Mcrafty1]

I wonder if there's a Phillips screw "dead center" under that instruction decal? Maybe an "inquiring fingernail" run across the back may locate the indentations of the screwhead ????BINGO! We have winner!!! Thank you for that suggestion. Its a 23A battery but I can order one for it. Thanks again.

[Mcrafty1]

I will add though in my defense, I wasn't able to feel it, I just peeled the label off to find it.