PDA

View Full Version : ARP Controller Install


DonnieBlitz
07-28-2018, 06:31 AM
Hi All, I'm wanting to install my new ARP 3.1 controller for my Norcold 2118 fridge in our Fuzion 4141 but can't get my hand in the back to install the Flue sensor.

My question is what I have to remove inside the coach to be able to slide the fridge forward just a couple of inches. It is trimmed out real nice on the inside and I don't want to foul it up.

Thanks

chuckster57
07-28-2018, 06:41 AM
Top and bottom trim come off and you should see two screws at the top going up and 2 at the bottom going down...OUTSIDE you should see two or three screws going through the frame into the base of the cabinet.

DonnieBlitz
07-28-2018, 08:13 AM
This is the interior trim. This is what I'm not sure of even how to start to remove it Chuckster. Thanks, bottom pic should have been rotated to the right 90 degrees

chuckster57
07-28-2018, 10:55 AM
Top trim: pulls out, be careful as there are clips that fit into slots on the refer frame. Lower: open doors and look for a screw at the corners. I have been dealing with Dometic refers for the last week so I'm going from memory here. I'm positive about the upper and outside screws......

DonnieBlitz
07-30-2018, 06:00 AM
Thanks, I popped the top and bottom off on the interior side and see many screws. Gonna pop the sides off and see there as well.

chuckster57
07-30-2018, 07:02 AM
Shouldn’t be any screws on the sides.