Jriggs10
05-31-2018, 07:35 AM
Hi! This is my first post on here, I have a Springdale 2011 5th wheel camper. I've had it about a year and our family loves it! We recently got back from a camping trip, as I was getting the RV off the truck, I ran the front jacks too high and it made a dying sound and stopped working. I moved it manually and it goes up and down and I just planned on manually jacking it up but not sure hulk Hogan could rotate that Jack more than a couple times. I looked around the switch (it has six connectors) to make sure they were all connected and didn't come loose. I then found the fuse which was blown, I replaced it, but nothing happened. So I looked again at the switch and think I might have pulled out a wire or two. Because I love to make easy problems hard and I'm really good at doing it, I pulled out all the wires when trying to just pull back the rubber sleeve to see the connections. There are six loose wires and I have nothing more than an educated guess as to which go where...I hooked then up as best I could tell and blew another fuse. Motor didn't turn on or anything, just an immediate blown fuse. I'm hooked up to power. I searched the forum for a wiring diagram, but it sounds like I would have better luck finding Jimmy Hoffa's body. Any suggestions, or should I just go back it off a cliff? Thanks!!