Furrion Camera Power

[KJD]

I just bought a 2019 320RS with the Furrion camera hook up installed. I plugged the camera unit into the installed connection coming out of the unit and it is powered up all the time without the running lights on or for that matter the truck connected. I called keystone and they said it is hooked up to the running lights. Well it is not, its got constant power. I even turned off the battery disconnect switch and it still has power. Is there a switch/fuse that is hidden somewhere that would disable this?

[chuckster57]

Welcome to the forum :wlcm:

This thread will help:
http://www.keystoneforums.com/forums/showthread.php?t=32950

[Hey Louie]

Hello KJD, mine does the same. I am going to try what Chuckster57 suggested in the other thread, but have not had a chance yet. I'll let you know what I find.

[KJD]

Yes please do. I am going to try and trace it down this week end and I will do the same.

[KJD]

I traced it down this weekend & on my unit it was hooked up to the accessory on the fuse panel and from that it went to the C02 sensor and from that to the pantry light and from that to the camera power. What I did was put a switch after the pantry light inside the pantry and all I have to do is flip the switch in the pantry and it kills the power to the camera.

[chuckster57]

Thank you for the follow up. I wouldn’t have guessed that one.

[Hey Louie]

Thanks KJD. Did you start by pulling the fuses until you lost power? Still haven't gotten around to mine yet.

[KJD]

That is exactly what I did, If I where you I would start with that one. Good luck:)