View Full Version : A frame tongue arm dimensions?
Jeepshots
05-25-2017, 07:45 AM
I'm not near my Bullet to take a measurement, but i'm looking for the dimensions for the A-frame tongue arm - width, and height. Basically looking for what size box steel i need to obtain to build bracketry that fits around the arm, for a weight distribution anchor point. I'll be at my trailer tomorrow evening, but would be nice to get a measurement before then... Thanks!
I'm not following the reason behind your request? Doesn't your hitch already include weight distribution?
2016 Passport GT 2810BHS, 2016 F350 CC DRW
Jeepshots
05-25-2017, 08:25 AM
It does. I'm building my own version of the Straptek system to see if i like it better than the chains.
Makes sense. Good luck. Let us know how it goes.
2016 Passport GT 2810BHS, 2016 F350 CC DRW
Jeepshots
05-25-2017, 10:30 AM
Well I took my lunch, and drove out to the camper. Measured the tongue arm - 2" x 6". Now i can buy the steel that I need to build the bracketry.
vBulletin® v3.8.9, Copyright ©2000-2024, vBulletin Solutions, Inc.