AC vent cover removal

[nesparky]

How do I remove these covers.
http://uploads.tapatalk-cdn.com/20160611/5118fe21c131500bf4a3ae49b41e7f13.jpg

[dwall]

I used a screwdriver and pry around edge. Mine snapped right off and back on.


Sent from my iPhone using Tapatalk

[Camping Buddys]

Just using your fingers, I did change three on our Outback with the ones that you can close the little vents.

[Outback 325BH]

Just using your fingers, I did change three on our Outback with the ones that you can close the little vents.



Where did you get yours that you can close? I was thinking just yesterday I wanted to do that!


Sent from my iPhone using Tapatalk

[Camping Buddys]

Amazon, just make sure that you measure the opening and the insert. In our camper I had to remove the other plastic part.

[Camping Buddys]

This is the new vent we installed, I changed three, 1 in the living room, bathroom and master. For the kids bunks I used the D & W (5840WH) Aireport Ducted Air Conditioner Ceiling Vent.

[Camping Buddys]

This is the D & W (5840WH) Aireport Ducted Air Conditioner Ceiling Vent that we used for the bunks.

[HBandWB]

How did you remove your AC vent covers? My vents look just like your picture. I need to remove one because it is partially blocked by some loose foil tape.

[flybouy]

How did you remove your AC vent covers? My vents look just like your picture. I need to remove one because it is partially blocked by some loose foil tape.

You are replying to a post that's over 4 1/2 yrs old. Camping Buddy's Last Activity: 04-05-2017 10:22 PM. I doubt they will reply. In the photos I see 4 screws. If you don't have the screws try gently prying on the outer ring with a plastic putty knife.

[HBandWB]

I was trying to reply to the original poster nesparky. My vents look exactly like the picture of his vents. Slots, no screws. I realize his is an old post but I was hoping nesparky is still available. How do I replay to a specific poster?

[flybouy]

I was trying to reply to the original poster nesparky. My vents look exactly like the picture of his vents. Slots, no screws. I realize his is an old post but I was hoping nesparky is still available. How do I replay to a specific poster?

HBandBW, I find it less confusing to quote the poster or address it to a specific poster as I have done. Otherwise you assume you're replying to the last post. Those air diffusers just pry off. A small screwdriver, a plastic trim removal tool or putty knife will usually work.

Added, the Op haven't posted in a over a year and a half either.

[JRTJH]

I was trying to reply to the original poster nesparky. My vents look exactly like the picture of his vents. Slots, no screws. I realize his is an old post but I was hoping nesparky is still available. How do I replay to a specific poster?

That member's profile information indicates: Last Activity: 08-25-2019 06:58 AM You can click on the member profile and the last activity is listed directly under the member's name.

[Northofu1]

I was trying to reply to the original poster nesparky. My vents look exactly like the picture of his vents. Slots, no screws. I realize his is an old post but I was hoping nesparky is still available. How do I replay to a specific poster?

Just pry gently with your fingers a little at a time. Or, you can buy a set of plastic pry tools.