Firemenfred
02-01-2016, 03:31 PM
thought i would post this for Raptor 300mp or similar TH's. if it in the wrong place just let me know and i will move it. my 2011 had sever rot on the sloped section near the ramp. my buddy who has the same model told me about his rot issue so i checked mine and sure enough i have the same issue. water under the bridge at this point so i decided to tackle it, since the dealer wanted 4K to repair.
i first tried to remove the rubber deck but the floor just peeled up with it. and of course the walls sit on the floors. most of the floor came up buy hand, it was so soft, the rest took a bit because it was tacked to the frame. since the rig is 102" and the floor was 1" thick, i use 2 sheets of 1/2"marine boat board (which comes with a 10yr warranty) and spliced them together with offset joints so they equaled the 102" and slid under the walls. i reattached it to the frame with self tapping screws, cut out the tool box doors. i have stalled at this point due to finding the right rubber diamond plate thickness. then it will be a lot of caulking and clean up.
if you want detailed steps and material just PM me.
i first tried to remove the rubber deck but the floor just peeled up with it. and of course the walls sit on the floors. most of the floor came up buy hand, it was so soft, the rest took a bit because it was tacked to the frame. since the rig is 102" and the floor was 1" thick, i use 2 sheets of 1/2"marine boat board (which comes with a 10yr warranty) and spliced them together with offset joints so they equaled the 102" and slid under the walls. i reattached it to the frame with self tapping screws, cut out the tool box doors. i have stalled at this point due to finding the right rubber diamond plate thickness. then it will be a lot of caulking and clean up.
if you want detailed steps and material just PM me.