Stabilizers ?

[timd3200]

Question the rear stabilizer on my Copper Canyon has me wondering. It has the electric stabilizers. Today when I was leaving park I forgot to raise them out of the way. When I raised the front to hook up to my truck. I then realized I had forgot. SO I lowered camper and then raised the front. When got home and unhooked I lowered the rear stabilizer the one side didn't come down until the other side touched then it came down until it touched. It is like there was a spot weld or shear bolt that held it in place that broke. The bracket that has the all thread in it that moves the stabilizers up and down is sliding back and forth. Question is that normal or do I need to install a shear bolt or spot weld to keep the bracket from moving around.
Thanks in advance. Tim

[BigBearWV]

That is how ours have worked from day 1!

[justlkn]

Ours too. One then the other.

[gkainz]

mine move somewhat together, but if you grab one side, the other will continue its travel unimpeded. Normal operation.

[timd3200]

Thanks for the info. I was worried that I screwed something up.

[WaltBennett]

You may have slightly bent something if it didn't work that way before, or maybe just got some dirt onto the screw. If they don't look like either one is not at a right angle to your frame, don't worry about it.

[timd3200]

Stabilizers all look square and straight. Worked just fine when I got home. Thanks again for the replies.