PDA

View Full Version : Slide issue Raptor


LeoM
06-08-2014, 03:36 AM
07 3712 living room slide starts to retract then stops about half way in. Release control pause 10 sec. hit the control again and slide finishes retracting. Checked hyd. fluid O.K. All other slides work fine without stopping. All slides extend with no issues. Any ideas?

PARAPTOR
06-08-2014, 05:09 AM
My Raptor has two slides and never go out immediately. Both start out large slide will hesitate part way out until bedroom slide all the way out then and only then will the large side continue out all the way. Same procedure in reverse when closing. Hydraulics not large enough to drive both slides out at once. I assume they have been like this from the start?

JAL
06-09-2014, 03:47 AM
I had the same problem with a 07 3612. It was a circut breaker by the house batteries. I had two breakers, held a meter on each while the wife ran the slide to find the one that was tripping. A trip to NAPA and now my slides don't stop half way to take a break. :)

blitherland
07-27-2016, 05:49 AM
what do these "breakers" look like? My raptor is clicking before it even moves the slide. I can manually run the slides so I think it's something other than the pump that's the issue.

bobbecky
07-27-2016, 02:47 PM
Probably like this:

http://www.keystoneforums.com/attachments/photobucket/img_208205_0_95a8a311bbcfe2a14af1825064133158.jpg