JT's elephant Feet

[audio1der]

Has anyone used them, as part of the JT's stabilizer system, or alone?
I need something to mount my stabilizer bars perpendicular to the scissor jacks to, and thought these would be an ideal base, but $150 for (4) round plastic feet??
I might just spray rubberized undercoating on some 5/8" plywood.

[JRTJH]

You might look at the BAL deluxe base pads. A set of 4 is $30 at Amazon.

http://www.amazon.com/BAL-20031-Deluxe-Base-Pad/dp/B000V0JAT6

[audio1der]

Thank you, but those aren't for scissor jacks, are they?:confused:

[Laredo291OH]

I know this is a link to the Jayco Owners website, but it shows some very good pictures of how to install the stabilizer bars. I just installed the BAL arms on our TT and did it like this on the rear jacks. http://www.jaycoowners.com/forums/showthread.php?t=7565

[michol02]

Not sure if this is what you're lookin for, but I used composite deck wood pieces that I bolted to the scissor jacks.
5551

[audio1der]

I know this is a link to the Jayco Owners website, but it shows some very good pictures of how to install the stabilizer bars. I just installed the BAL arms on our TT and did it like this on the rear jacks. http://www.jaycoowners.com/forums/showthread.php?t=7565

Wonderful- thank you! If I had the same extension off botht the right and left sides it would allow me to pass a bolt through which will act as the pivot pin. Simple and effective!
THANK YOU!(tx)"bouncey: