View Full Version : Lugnut question
Robinsons
04-25-2013, 03:11 PM
Getting ready for our first trip with a Raptor 297SE 2013. Want to be prepared and cannot find the correct size of the lugnuts on the 16" wheels. They do not appear to be a standard size. Has anyone encountered this?
Thanks for your input.
Bugle Boy
04-25-2013, 07:26 PM
Getting ready for our first trip with a Raptor 297SE 2013. Want to be prepared and cannot find the correct size of the lugnuts on the 16" wheels. They do not appear to be a standard size. Has anyone encountered this?
Thanks for your input.
Are you talking about the thread size or the wrench size?
Are they possibly metric?
f6bits
04-25-2013, 07:34 PM
Would you happen to have a star wrench? They usually have two metric ends and two standard ends. Or maybe a socket set so you can pick around until you find the right size.
therink
04-26-2013, 02:57 AM
I believe the lug nut size is 13/16".
Bob Landry
04-26-2013, 03:44 AM
I believe the lug nut size is 13/16".
I think mina are also that size. Borrow a set of sockets , if you don't have one and verify it. You'll need a socket and a short extender to use with your torque wrench. You are going to check lug torque also. Aren't you? Harbor Freight sells them cheap, like less than $20 for one with 1/2" drive. I check mine before every trip.
I think mina are also that size. Borrow a set of sockets , if you don't have one and verify it. You'll need a socket and a short extender to use with your torque wrench. You are going to check lug torque also. Aren't you? Harbor Freight sells them cheap, like less than $20 for one with 1/2" drive. I check mine before every trip.
X2 "bouncey:
vBulletin® v3.8.9, Copyright ©2000-2024, vBulletin Solutions, Inc.