Quote:
Originally Posted by Baguak
When I disconnected power and tested two batteries registered 13 volts while the third registered 12.
Sent from my iPhone using Tapatalk
|
Did you run the furnace and test the voltage after about 15 minutes with the furnace still operating? Many "weak" batteries will read over 12 VDC when first removed from a charger and with no load, but they will rapidly lose their charge with a small load and will read 11 VDC or less in a very short time.
Typically, a fully charged operational battery will read about 12.6 VDC an hour after being removed from the charger. If two of yours were reading 13 VDC and one was reading 12 VDC, you may have a bad battery that's pulling the other two "down" preventing all three from fully charging. Or, you could have a different problem....
In any situation, if the system works when on shore power and does not work on battery power, it's not the propane, furnace or CO monitor that's at fault, it's the power source which is the only thing that has changed between being "plugged in and running on batteries".