I made some 2"x12" blocks for under the jack feet. The rear I use 3 of them 12"x12" square and have a handle to pick them up with. I think it helps with movement in the trailer because the jacks are not extended as far and seem to not move a much when moving around inside the trailer. I have a single 2"x12" that I put under the front jacks, and pull the pin to extend the jack the majority of the way.
I believe our system is working properly, I just think its pretty crappy that it has to be close to level for auto level to work. Every time I have gotten the "out of stroke" message, I was no where near fully extending them. In fact sometimes only a few inches. From what I have read before, if one of them extends more than 2 inches more than another one, it gives that error. I wish it would just say "too unlevel" or something. I also wish it would let you just manually retract the jack instead of having to "hard stop" all of them every time this error happens.
__________________
2015 Montana High Country 305RL
Previous campers:
2008 Rockwood Ultra Lite 2603
1998 Coleman Grandview pop-up with slide
Trucks:
2006 Ford F350 CC, SB, DRW, 4x4
1992 Ford F150 SC, SB, 4x4
|