No work to my knowledge - we took delivery on it on 4/28 and I did not nice the issue until today.
It is cooling but it just looks like they placed the fin assemble off-center. There are screws that hold it in place - wonder if the screws can be removed and it re-centered and screwed back in place.
I was worried about condensation too.
Will contact Norcold and the dealer.
Found this on the net. Someone had a similar problem but maybe not as extensive as ours:
I obtained some quality pipe putty from local hardware store, I was able to work this into that gap along the vertical edge, and completely seal that up. I also used the end of a somewhat narrow screwdriver, and went across the bottom of the fins, working that putty into the lower horizontal seal. I was careful NOT to get any pieces down into that water collection tray under, which could plug up that drain line to the outside. This worked quite well, and I hope this "seal" works. I could have used like a caulk, but don't want to "glue" this unit in, in case we have to remove it someday. I think this plumber putty will stay flexible, and if well anchored and worked into the cracks, will stay in place. Will see.
__________________
RV - 2017 Avalanche 320RS
TV - 2011 Chevy Silverado 3500HD LTZ CCLB Duramax SRW 4X4
|