First, the bracket that's required with the BAL stabilizer system is used to attach the bar end to the lower part of the electric stabilizing jack. You can do the same thing with a 1/4" hole drilled in the attachment where the jack foot attaches to the jack ram/scissors components. Adapting BAL stabilizer bars to any jack system is relatively simple and many require a bit of "thinking" about how to attach them. I'm speculating when I say this, but the reason there's no specific part available is because it's a common hardware item or a personally made adapter and not a "hard to manufacture specific component"....
As for X-Chocks. they ONLY stop axles from rolling fore/aft. They do NOTHING to stop the up/down spring action which causes the trailer floor to bounce when walking inside. Some people use them to chock their trailer, but once you buy them and use them, you'll see that they loosen with use and are a poor way to chock your trailer against rolling on an incline. I'd strongly urge you to use wheel chocks even if you install X-Chocks between your wheels.
__________________
John
2015 F250 6.7l 4x4
2014 Cougar X Lite 27RKS
|