Another slide-out question!
You can adjust the Slide height.
Retract room about 12 inches.
Look underneath and you should find a bolt sticking down at the outer edge of the rails. The plate should have 2 bolts holding the rail to a plate on the slide. MAKE sure the VERTICAL bolt is touching the plate, loosen the horizontal bolts and then loosen the vertical bolt to drop the outside edge of the slide. Do BOTH ends THE SAME amount, and small adjustments. Tighten the horizontal bolts and run the room.
On the "power" rail there should be a large threaded rod. You shouldn't need to adjust it.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|