Xantrex freedom x 1200 120V sin wave inverter

[Fuel Guy]

I finally bought the inverter for the pre-wired outlets for my keystone cougar 5th wheel. My question is how do I hook up the outlets? It is on a loop going to the 3 outlets, and from the converter. Do I hook up both ends of the loop?

The fuel guy

[bsmith0404]

Trying to understand what you’re doing here. If I understood what you said, you wired the inverter to the converter????

[chuckster57]

Look at your inverter it should have:

AC IN

AC OUT

DC IN

AC in- look at the Romex and when you determine which side is SUPPLY that connects to the AC IN

AC OUT- look at the Romex and when you determine which side goes to the outlets that connects to the AC OUT

DC IN- connects to the battery(s). Pay very close attention to the proper size (gauge) wire depending on length.

DO NOT make any AC connections with the shore power on!!

[Fuel Guy]

It has the auto detect switch to detect shore power vs battery. Thanks for the info, I will look tonight when I get home.

Fuel Guy

[Fuel Guy]

Originally Posted by bsmith0404

Trying to understand what you’re doing here. If I understood what you said, you wired the inverter to the converter????

Bsmith0404, I am not hooking up the inverter to the converter, but instead to the outlets that are pre-wired.

Fuel Guy

[bsmith0404]

Ok, just trying to understand how you’re connected, you said it was on a loop from 3 outlets and the converter.