2010 3750FL Front Landing Gear

[team222]

Bought 3 years ago

1. Constant issues with the landing gear not getting high enough to get on the hitch with the single original battery

2. Problem still exists after installing 4 deep cycle 6 volt batteries and new motor!

Help.... and thanks in advance

Mike

[roadglide]

I installed 6500 lb motor gear box for a friend and straighten the landing gear leg. It's a simple system .

[flynaz]

I am starting to have the same issue. I replaced the landing gear legs when I first got my 3455 SA. They seemed to hang at a certain point. The legs were binding. So my next attempt is to replace the motor 65K and a new gear box. I’ll let you know if that fixes mine!

[flynaz]

Originally Posted by roadglide

I installed 6500 lb motor gear box for a friend and straighten the landing gear leg. It's a simple system .

Roadglide, How did you straighten the leg??

[flynaz]

I just finished replacing the O.E.M. Landing gear on my 3455SA for the second time. This time I installed Ultra-Fab Deluxe Electric Landing Gear Set part # UF17-943010. I was concerned about having to weld the brackets on but the landing gear bolted right in. I made a switch bracket and mounted it in between the existing landing gear and stabilizer switches. The new landing gear lifts the rig with ease.

[roadglide]

Hope the other welds look better then the weld seen in the pic.

[flynaz]

Originally Posted by roadglide

Hope the other welds look better then the weld seen in the pic.

Yes I agree, not a very good job for sure.