2010 Fuzion slideout not retracting

[kellydog98]

I have the hydraulic system. The bedroom will not come in. The other 2 work
just fine. My wife and I was able to push in the bedroom slide, phew!. Batteries all charged, no obstructions inside or out. Fuses and circut breakers all OK. Hydraulic fluid up to par. Any ideas? Thanks, Kelly.

[Cnc_hemi]

Some units the bed slide is electric not hydraulic. Most are a cable system and the motor is above the slide in the coach. There should be an access panel that you can remove. Check there

[kellydog98]

Thanks, is the pannel easy to get to under the bed itself?

[Cnc_hemi]

Look above the bed if there are any panels on the head board up top. If not it may be under the bed. With saying all this I'm taking that the bed is on the slide and not the wardrobe. Can you see any cables on the slide?

[kellydog98]

Thanks for your reply. I finally found the issue. The bedroom slide has 4 bolts seated under the press board and attached to the ram. The wood under each bolt has rotted away and therfore the bolts and bracket became unattached to the ram. Now I'm plotting my repair. Kelly

[Cnc_hemi]

Cool, I'm glad you found it. Put treated wood back in there so it will not rot again. Hope all goes ok.

[kellydog98]

replaced wood, added 1/8 x 42" x 12" piece of steel plate on top which I mounted the ram's L-bar. I'll never have a problem with this slide out floor again! Hope you never have this problem. Kelly.