Access slide motor, how to...

[Danno]

On my 2010 Raptor 361LEV I need to access the master bed room closet slide motor and can't seem to find any access.

I don't see anything from the out side or the inside. My only guess is the front of the moving floor panel comes off but I don't see any fasteners.

Can anyone steer me in the right direction? I know I will find it but it might just be quicker to ask.

Two reasons I need to get in there, (1) last winter I felt a lot of cold air coming from that area. (2) last week while closing that slide I heard a pop & shake I have never felt before and would like to investigate.

Also where is the override? its under the step for the galley/sofa slide, but where for the bed room closet slide.

Thank you in advance
Dan
______

[chuckster57]

What type of slide is it?

I doubt it’s hydraulic, but it could be cable driven or gear driven.

[Laredo Tugger]

My bedroom slide motor is under the bed (king) on my Laredo.
They exposed the motor during my PDI because it was extended to far out. It was gear driven and they used a wrench on the shaft end to retract the bed. The shaft end was facing the foot of the bed and as a future project I am considering drilling a hole in the platform base to allow a tool to be inserted and turn the shaft by hand. As it is now you must remove the mattress,unscrew the plywood top to access the motor/gear.
Good luck
RMc

[Tunnel_Vision]

Originally Posted by chuckster57

What type of slide is it?

I doubt it’s hydraulic, but it could be cable driven or gear driven.

It is a bottom mount rack and pinion. According to Lippert componets its called a "Above Floor slide assy."