Our bed slide does not have 120 volts in the slide, only hydraulic lines and 12 volts. Those two things up into the floor below the bed and the 12 volts that feed the reading lights are supplied with a very flexible wire that is able to move when the slide is operated. I had always thought, if I needed to have 120 volts to the bed, I would pick up 120 underneath and feed it up through the same place the hydraulic and 12 volts come, then convert it to a flexible cord, probably one of those coiled cords, that can move with the slide without hanging up. This is a photo of our bed with the plywood removed. The photo doesn't show the entry point, but it is just below where the black and orange hydraulic lines are going in the lower right of the photo, and that is also where the 12 volt line comes up.
__________________
Bob & Becky
2012 3402 Montana
2012 Chevy 2500HD D/A CC
|