Slide-outs

[Jketterer]

Hello!
I have a 2008 keystone sprinter 311 BHS. I have no problem putting my slide-outs out. However, when it is time to close them up I seem to have to hold and push the in button several times before it moves. Any suggestions? It doesn't make a sound or anything. It's like there is no power connected to the switch.

Ani thoughts or ideas are greatly appreciated!!!

[Canonman]

Most likely a bad switch. Power is there because it opens the slide. Switch is "momentary" type so must be held in to maintain contact for the motor to run. Likely the contacts have just separated due to wear over time. If you can access the switch and remove it, replacement should be pretty easy.