Quote:
Originally Posted by Al Sandoval
Thats correct when no cable available all 3 Tvs wok perfect and same Chanel's
Hook up to CG cable and had to switch main tv to the other connector plate got two there works fine all Chanel available are there.
The bedroom tv I change it to the other box inside the cabinet turn the power booster off,Program remote. And it that's not work on any combination
TV in the Garage gets a couple of the Chanel's only one box available there.
The only thing the I see on both of this Tvs is the keeps saying analog Chanel's and no digital Chanel's available can that be the problem.
|
Not totally following you but I will take a shot at this: I assume we are referring to two modes of operation 1.) antenna and 2.)CG Cable
In mode 1. all TV's working fine each TV receiver picking up a signal through the antenna (Booster on). Signal feed from antenna sent to each connector plate located near each TV. In this mode of operation all four connector plates are connected together (one for each TV and one connector outside labeled CABLE)
In mode 2 (CG CABLE) you connect the CG cable to the outside connector again labeled CABLE and setup each TV for CABLE signal using each TV's remote, you should receive a cable signal to each of the three TV's. Please note that Booster has to be off in this mode of operation
Now there is another outside connector labeled satellite that when the CG cable is attached here the signal is only sent to a separate connector behind the main TV which is different than the one the main TV is connected to in modes 1 and 2.
From your description sounds like you connected the CG Cable to the outside satellite connector and not the Cable connector. You said you changed the main TV connector to the other connector which would have connected the Main TV to the Satellite connector outside. None of the other TV connectors are connected to this signal, therefore will not receive the CG Cable signal.
You said Bedroom TV got no signal but Garage TV got some channels?? These two TV connectors are electrically connected together and to the antenna at this point. Only thing I can figure the channels you are seeing are via the antenna and not stations from the CG Cable??
As stated above if you connect the CG cable feed to the outside CABLE connection should work fine, remember in this mode Booster is off.
With information at hand this is my two cents
__________________
2013 RAPTOR 300MP w/Rear Patio Deck NO Folding Side Ladder
2013 Silverado 3500HD LTZ CC LB 4X4 DRW
Duramax 6.6L Turbo Diesel; Allison Trans
Reese 20K; Carlisle Radial Trail RH/HD; TPMS (12 Tires)
Veteran
PSU (GO LIONS)