JT Strongarm Stabalizers - Gound Control 3.0

[Ewad-29RLI]

Considering installing JT's on the 29RLI. The auto-lever can be a little fussy when outside influences are presented. Has anyone had issues using the JT Strongarms with the auto-leveling?

Also, I,m told there is a replacement plate for the rear jacks that allow connection. I can not seem to locate those.

TY in advance.

[JRTJH]

I believe there used to be an optional round footpad that you could buy to replace the ones that are currently on your stabilizer jacks, but the JT Strongarm kit comes with a replacement bolt to attach the bars to the bottom of the stabilizers. You just remove one of the existing bolts, slip the new bolt with the "bar eye" into the bottom of the stabilizer/pad and then attach the stabilizer bar to the "bar eye" on the new bolt.

Here's a photo:

[tallen]

Have you look at the.... "STEADYfast Stabilizer System for Parked 5th Wheel, Travel, and Camper Trailers with Round Jack Footplates and Auto Power Leveling"

https://www.youtube.com/watch?v=nWGWwMCXmgc

Not sure if either one is better than the other. Just putting it out there.

[AZtrailer]

We have the JT's on our 24RDS which has the Ground Control 3.0 system and have not had any issues with auto leveling. We only have them on the front landing gear, did not install them on the rear levelers as I don't think they would make much difference there and there wasn't an easy way to connect them to the rear levelers.