water heater

[gleanerman]

have 2013 280rls have a problem with DSI water heater it worked good for half day then no hot water have propane DSI switch is on reset switch on heater ok has anybody had this problem?

[JRTJH]

Check the 12VDC fuses in the converter/electrical control panel. Make sure the HWH fuse is good. The DSI switch may still operate with the fuse blown in the panel.

Turn the inside HWH DSI switch off, let the HWH cool down (or run the hot water out of it) until it's below 110*F. Then hit the reset button under the black rubber pad. Turn on the DSI switch inside. It should fire.

If your furnace is operating normally, you're almost guaranteed to be getting gas to the HWH as well.

[abneynormal]

is the little led above the rocker switch lit? mine sometimes fails to light if so turn the switch off and back o the little led should go off if not try blowing in the burner area trash can get in the pilot and make it not work.