Permanent EMS install
Seriously doubting if I want to install this or just exchange it for the portable.
Zero room to work, I would have to move the inverter over to make room for the EMS. Not a huge deal but not sure I want to put more holes in the floor than I need to.
It’s 6 gauge wire. I have a stout wire cutter but I don’t think it’s enough to make a clean cut. Thinking it would be better to use the angle grinder with a cutting disk, but again little room to get in there. I was going to unhook the wires from the fuse box and buy a length of wire but they must have used the Hulk to tighten the screws and I stripped the heads. Ugh.
|