TV hook up for local stations

[Krubenzer]

I have a 2018 Springdale 5th wheeler. When I set my channels for the television living room I get 30 some channels. But when I set the channels for the TV in the bedroom I only get 7 channels. The living room TV is plugged into the outlet which has the amplifier. Is there a way to connect the bedroom TV to that same amplifier Outlet? Also the camper came with a connector that seemed to connect two outlets together when I took it off I could not remember why it was there and how it was set up. any help please would be appreciated thank you

[Wyldfire]

Originally Posted by Krubenzer

Also the camper came with a connector that seemed to connect two outlets together when I took it off I could not remember why it was there and how it was set up. any help please would be appreciated thank you

I believe the small jumper cable you removed is to connect the booster to the bedroom outlet. It is removed to hookup satellite TV. The jumper should be put back in connecting the two outlets on the same plate to each other to get over the air channels in the bedroom and living room.

[chuckster57]

If you remove the booster, on the back side there will be coax connections. One will be antenna in another for Cable in and TV2 and possibly TV3.

Your bedroom tv is hooked up to either TV2 or TV3. Check the coax, I’ve seen loose ends, center conductor cut short or too long causing a short.

That loop is for a satellite receiver for the living room tv. It should be in place for the tv to get OTA reception.