Hi All.
Just received my new replacement remote from eTrailers and getting ready to install it. (Yes... $235 stupid tax. Don't leave it on the Rail bed when hooking up.
) Have read three different sets of directions which all seem to show two steps. First configuring the remote and then synching it to the GC 3.0 controller. It seems that you can synch two remotes, and that you don't have to configure the second one, if I'm reading the instructions correctly.
My thought is that, if I want this remote to work the same way as the old one, and I technically have the first one already configured and synched (although it's unusable due to crushed screen) I should NOT configure the new one, but just synch it. Is that correct? If I did configure the new one before synching, will the GC 3.0 receiver synch to the new configuration, or cause problems because the two remotes are not configured the same? I will be throwing out the dead old one when the new one works.
Anyone got experience?