Cable/Winegard wall plate issue
Here is my issue, cannot scan and get any channels while connected to campground cable. Long story shorter, with a tester, i get a clean line from the exterior connector all the way the the wall plate. I tested all cables separately and connected, from the outside to the jumper connector to the wall plate. The issue is when I connect the cable the the plate, the tester shows a short. I bought a new wall plate thinking the original one may have been defective, new one still indicates a short. I tested while the amplifier was off. The booster works and I get local channels fine through the antenna.
Thanks for looking,
Mark
|