using auto levelers after slides are out

[CraigB]

Just got a new Montana 3402 RL with auto levelers (the single best invention in trailerdom). When it levels prior to extending the slides, after slides are extended it's low on the street side. Can I re-level after slides are out?

[mhs4771]

CraigB, quick question "Are you sure it's level with the slides still in?" We had the level-up on our previous Montana and now on our RW and have never seen any difference between slides in or out. May not have been level when the zero point was established. Any way, if I were you I'd get it level with the slides out, then do a re-calibrate on the system to learn the level position with the slides out. The system isn't perfect and sometimes will go out of calibration. There should be instruction in the user manual for the calibration routine.

[CraigB]

I didn't check to see if it was level prior to extending slides. Good point. It's not off very much, just enough that "I" know it's not perfect. I will check the directions. Thanks a lot.