Removeable table floor brackets on slideout unsecured

[floorspy]

2015 Passport Ultralite, floor brackets that hold removeable table to floor in slideout installed over carpet then screwed into floor came loose, table very wobbly. Anyone have fix or solution for this problem?

[Frank G]

If these are the round metal post holders, pull the screws, rotate a little and screw it down again. Careful to not over tighten.

[floorspy]

Thanks, I did this and seems to be holding. We are also very careful with leaning on table.

[Kitesurfer]

We had the same issue in the Passport 2400bh. We rotated and I was going to install in the same part of the carpet. But I measured the spread on the table top holes and realized that the legs brackets were initially spread about 1" further apart as compared to the table top. When I aligned it perfectly it wobbled a lot less since the posts slid in much further and straighter.

[PhillyPhan]

Do you know what size/type screws are used to bolt these down? We just picked up a used Cougar and the previous owner removed them because the table broke. He misplaced the screws so now I can't reinstall them. Not sure how long of screw is needed or can be used.

[Kitesurfer]

I'm not a 100% sure. It was approximately 5/8" or 3/4"pan head phillips screw.