Need Fuzion owners advice as I recently upgraded to a '14 375 missing documentatiion

[DucBill]

Specifically looking for info on where the switch is to turn the led lite string on the awning rollers which are Carefree Elipse units. Switch in command ctr just moves them in or out. There is a short pigtail of 6 conductors in bed room upper cabinet with phone jack type connector but nothing to connect to. Any info is greatly appreciated as the selling dir couldn't answer even though they handle this Keystone line.

[ctbruce]

Dont have your unit so these are just WAGs. In my Impact, the awning lights are in a group of 3 that also controls the bedroom and kitchen overhead lights. Took a long time to figure out because the switch didn't seem to do anything.
Do you have a remote or In Command system?

[DucBill]

Originally Posted by ctbruce

Dont have your unit so these are just WAGs. In my Impact, the awning lights are in a group of 3 that also controls the bedroom and kitchen overhead lights. Took a long time to figure out because the switch didn't seem to do anything.
Do you have a remote or In Command system?

thanks for your quick response ctbruce I have InCommand but the awning function is open and closed only and exterior lighting option doesn't turn them on or off either so not sure where to look but their not on the interior control cabinet. Maybe a Fuzion owner of similar agr uniy will chime in thanks again for shedding some light on the subject pun intended.[emoji3]

[ncbound123]

On my 14' 395 the LED awning light switch is located just inside the front door. It is in a dual switch plate, one operates the interior main lighting and the one to the outside operates the LED awning lights.

[roadglide]

Originally Posted by ctbruce

Dont have your unit so these are just WAGs. In my Impact, the awning lights are in a group of 3 that also controls the bedroom and kitchen overhead lights. Took a long time to figure out because the switch didn't seem to do anything.
Do you have a remote or In Command system?

Our Impacts are fusion with out some of the whistle and bell's. I went to the forums and got answer about the awning light switch . I know the awning has to be fully extender to see the lights

[DucBill]

Originally Posted by ncbound123

On my 14' 395 the LED awning light switch is located just inside the front door. It is in a dual switch plate, one operates the interior main lighting and the one to the outside operates the LED awning lights.

Thx NC Bound 123 mine has switches on side of control ctr x from front door maybe I've got a short or blown fuse to track down.

[DucBill]

Originally Posted by DucBill

Thx NC Bound 123 mine has switches on side of control ctr x from front door maybe I've got a short or blown fuse to track down.

Actually found only a few LEDs working in string so time to replace, any recommendations other than Carefree original replacement part?