Quote:
Originally Posted by jack65
OK, vacation is coming up and this has me worried a bit again.
I was looking at the trailer where it is stored today, inspecting the bubbles I have on the front (that problem is in another thread) and decided to check on the sliders. the one on the right appears to be separating a bit at the top front. Is the L bar supposed to be at an angle like that too? See pics.
I'm going to put a flat board on the bottom with 4x6 blocks under and on top of a jack. That should keep it from moving especially while traveling.
|
Add the fender washers to each screw. If you need to, go up one size of the last two screws. Don't do the bigger screws unless it is stripped or loose, though.