[PARAPTOR]

Okay, these posts seem to be once again centered on energy management. although the more recent posts were related to the 110 AC portion of the RV power system, surge protection, EMS remote monitoring, these posts relate to the 12 VDC portion. Just as on the AC side just knowing the voltage level, although important does not provide enough information for overall analysis and planning. Knowing the voltage, as well as, the current (power) on the AC side enable one to determine for example what current is drawn from each device. One can then determine/plan what can be turned on and stay within the rating of your rig (basically 30 or 50 amp).

Same applies for the 12V DC side, just knowing the voltage does not provide enough information. Just like on the AC side nice to know what current is drawn from each 12V DC device. For example determining what type/size batteries do I need to install, capacity (Amp Hour). Nice to know where you are now before you plan what/where you want to do/go. Also for troubleshooting what is the current output of your converter at the various stages, etc

Knowing more than just voltage levels on either the 110V AC or 12V DC side is equally important for troubleshooting and planning involving these two RV power sources.

Yes there is a point where it is overkill (flashing lights , etc) on any thing, I think if you want to monitor power you need to know more than than voltage level. Okay stepping Down