Keystone RV Forums - View Single Post

WaltBennett · 11-01-2014, 04:36 PM

I had one of those single motor setups with the square tube running from one side to the other - that also had a plastic gear box that was starting to fall apart. It would wobble up and down as well as the motor itself. Bought a much heavier duty Bulldog system with a motor on each leg (same size as the single on the old one) for around $340 delivered and installed it myself. Had to cut a small square hole in one side interior bulkhead and one to mount the new switch panel, but everything else was just wiring. I did add a locking thermostat cover over the switch panel, but that was all. Since I got the 7k lbs lift each leg set, they are slow, but I can lift the whole Montana if I want to.

11-01-2014, 04:36 PM	#15
WaltBennett Senior Member Join Date: Apr 2013 Location: Haymarket, VA Posts: 382	I had one of those single motor setups with the square tube running from one side to the other - that also had a plastic gear box that was starting to fall apart. It would wobble up and down as well as the motor itself. Bought a much heavier duty Bulldog system with a motor on each leg (same size as the single on the old one) for around $340 delivered and installed it myself. Had to cut a small square hole in one side interior bulkhead and one to mount the new switch panel, but everything else was just wiring. I did add a locking thermostat cover over the switch panel, but that was all. Since I got the 7k lbs lift each leg set, they are slow, but I can lift the whole Montana if I want to. __________________ '06 F350 Lariat turbo diesel dually, Curt 20k, Softopper, Aerosheld, coolant filter, air bags '10 3665RE Hickory, wet bolts, Trimetric battery monitor, 4 100w panels & Morningstar TS-45, still tweeking!