Keystone RV Forums - View Single Post

Hoodlatch · 05-21-2018, 08:08 PM

Hi all,
I’ve done many upgrades inside my 14 Bullet since I bought it new. 100% led lighting, accent light strips, 12v usb chargers in key locations. Just put flush mount reverse lights in rear bumper since my HD slinky don’t fit in there anymore.

I’m no 12v camper expert, but I’ve upgraded most of my toys and usually can get it done safely.

The time has come for a new battery, so I put 2 golf cart batteries in a century dual battery box out front. Added a nice disconnect and have a victron 712 to install as well as a pd4655 smart charger.

My question I’m not finding a solution to is the stock + wiring outside the front of the travel trailer. Everything is piggybacked on 2 “isolation” blocks. I would like to have a better weatherproof distribution block. I used all 4 awg wiring (and have the same to run back to charger), and the lugs are a little big for the small stock blocks... and if I can load a pic, you’ll see how rusty these weathertite units are.

Thanks for any input!

05-21-2018, 08:08 PM	#1
Hoodlatch Member Join Date: Jun 2014 Location: Pittsburgh Posts: 51	TT exterior wiring help/ cleanup Hi all, I’ve done many upgrades inside my 14 Bullet since I bought it new. 100% led lighting, accent light strips, 12v usb chargers in key locations. Just put flush mount reverse lights in rear bumper since my HD slinky don’t fit in there anymore. I’m no 12v camper expert, but I’ve upgraded most of my toys and usually can get it done safely. The time has come for a new battery, so I put 2 golf cart batteries in a century dual battery box out front. Added a nice disconnect and have a victron 712 to install as well as a pd4655 smart charger. My question I’m not finding a solution to is the stock + wiring outside the front of the travel trailer. Everything is piggybacked on 2 “isolation” blocks. I would like to have a better weatherproof distribution block. I used all 4 awg wiring (and have the same to run back to charger), and the lugs are a little big for the small stock blocks... and if I can load a pic, you’ll see how rusty these weathertite units are. Thanks for any input!