The bathroom vent/fan in our Sprinter is powered only when the bathroom lights are on. The fan is a POS. I would replace it with a remote controlled model but so far I haven’t been able to get a hot wire to it without putting a hole in the wall. I have to stand on the toilet to open the vent and turn on the fan. There is no cover over the vent so we can’t leave it open. I may have to make one of those sticks for now.
The vents in the lr and br didn’t have fans. I replaced the vent in the living room with a Maxxair with a cover. The ceiling is low so I went with the manual model. I got lucky fishing wires to the living room fan. It was not pre-wired. I didn’t buy the fan until I got the wires in place.
I put a cover on the bedroom vent so we can leave it open and would like to install a Maxxair but again, it’s not pre-wired for 12 volts. The br is pre-wired for a 2nd A/C unit.
It’s hard to fish wires in these trailers.
|