Quote:
Originally Posted by jaitken0016
The black rubber rest buttons were ok. THe DSI is clicking and the flame will be lit while it is clicking. As soon as the ignitor stops, so does the flame. This was initially tested when the water was cold, so the over temp I wouldn't think would be an issue.
|
It sounds like the flame sensor on the control board has failed. As "slow" posted, you probably need a new control board. It's easy to remove/replace the board, and they are available at almost any RV parts store. Dinosaur Electronics builds replacement boards that are reported to last longer than the OEM boards and are usually somewhat cheaper to buy. Information on Dinosaur igniter boards can be found here:
http://www.dinosaurelectronics.com/ Or, you can contact any RV parts store to purchase an OEM igniter board. Since you're still in warranty, you should contact your dealer. They may be able to get you in for repair with little delay, or possibly troubleshoot your system and send you the parts for installation as a part of the warranty. Good Luck !!!