Almost every single shelf in almost every cupboard in our Keystone Bullet Premier has fallen down, not from overloading, but from poor design. Every single shelf in each cupboard has 'runners' screwed to the walls on all four sides / edges; however, two of the four 'runners' are ABOVE the shelf and the shelf is only stapled up to the bottom of the runner. This is the poorest and stupidest assembly I've ever seen. No strength except the friction of the vertical staple into the soft fake wood of the runners. In addition there are no more than 3 screws holding each runner to the thin walls. No adhesive was used at all!
I cannot figure out why the shelves were assembled this way. Removing them and putting the 'runners' under the shelf has not been a major task, but why was it not done that way initially? Does anyone have any insight regarding the assembly process and why it is assembled this way?
Are we the only owner with this issue, or is it common?
