[ChuckS]

I’ve had the same problem occur when plugged into shore power and we experience a power surge at the house...

You may find next time you use your six point level up it won’t auto level correctly...if so just level manually and then recalibrate the auto level.

Also..in your front compartment located up high you will find the control module to the Lippert system...you can simply disconnect the single red wire connection on the control module “indicated with yellow arrow” and wait a minute and plug back in..

This will reset both the control module and the control panel...power to everything comes from this single red wire that is wired directly to battery and will have an inline fuse near the batteries as well..

One more issue you may experience when you go to use the RV when weather permits is your thermostat may not function right...If so simplly do a reset on the thermostat..

If you have the in command system that also may have issues and require a BCM reset..

Pic of level up control module and power wire location.....