Quote:
Originally Posted by KSH
I made sure he wasnt using the zerk, well i asked anyway. He said that's a bad way to grease them and they take them out to inspect them and grease them.
Is he supposed to adjust or do something to the brakes when he did the bearings?
|
May have had to back them off to remove the hubs & should have tightened them up after reinstalling the hubs, at least that's the way I do mine.
Here's a set of right & left brake backing plates, note the magnets on the bottom of each, should always be on the bottom, if the axles were/are upside down that magnet would be up, the 5 bolts seen in the center hold this assembly to the axle tube & only fit one way onto the tube, shown in this pic is how they are mounted.
