Quote:
Originally Posted by Scimsgirl
Replaced 30 amp fuses. I have heat! Haven't tried the water yet. I filled the tanks but that was three weeks ago. One plug is a bit "rigged" the other should be fine. More so, most info says to fill the water heater too. Pretty sure I know where it is but looks like I will need to figure out how to fill it. There is a metal piece in front of a circular opening that looks like it should move. I'm afraid of breaking it if I mess with it too hard. Couldn't find a funnel last night.
I tried starting the refer with the stove and oven going. No luck. It keeps flashing the LP light after about 30 seconds to a minute.
|
The single 12 volt battery will not run the furnace for very long and you should be careful to not discharge it too deeply (not sure what type of battery you have... true deep cycle or hybrid/engine start). Also not sure a single 100 watt panel will be enough to recoup post sundown losses... energy management will be fairly essential, with your current setup.
Good luck, there is a great wealth of knowledge here, just waiting to help you
-Brian