Quote:
Originally Posted by Sulphur1
Sonofcy The Darco looked like it was about to tear in the centre of the large slide so after seeing another poster using UMHW I counter sunk / screwed UMHW strips to the underside of the Darco. The slide with UMHW strips runs on the wear bar a lot smoother / faster. Downside floor seams to be soft OSB & screws could work out. May re-insert with glue. I didn't go with the UMHW tape as the Darco scuffing etc looked like it's under a lot of stress & thought it might tear of & rip the Darco with it
The smaller Bedroom slide underside is covered with a different surface that the 3 rollers run on. However it is lifting in places - no problem yet...……..
|
What width and thickness UMHW strips did you use? Where did you buy them? And if you did the install again you would use an adhesive?
Thanks
RMc